Dollar Days featuring a Night for the Armed Forces and First Responders + Demo Derby

FRONT WHEEL DRIVE CLASS

1. All judge ’s rulings are final.

2. 1980 or newer cars. Pre ran cars ok. If running a pre ran doesn’t mean you can crease, tuck

   or weld on anything. We can tell the difference.

3. Cars must be 100% stock!!! No aftermarket cradles, struts or spindles. No cross breeding.

   Entire drive line must be same as car. (Chevy to Chevy, Ford to Ford). Must be factory engine.

   Pipes through hood ok.

4. Drivers door may be welded. All other doors must be chained or wired. No more than 6

   places.

5. Trunks must be chained or wired. No more than 6 places. TRUNKS MUST BE OPEN DURING

   INSPECTION! No welding or adding metal. No welding washers for holes.

6. Hoods may be bolted in 2 places sheet metal to sheet metal. No all thread. May be wired or

   chained in 4 spots. 1⁄4” chain or 2 strands of wire per hole. It must be sheet metal to sheet metal only. No welding washers for holes. Must be 12” hole in hood in case of fire. Hood must be open for inspection. Remove hood latch.

7. Must use tires. Must be stock wheels. Any tire ok.

8. Gas tanks may be moved or left in stock position. Fuel cell preferred but stock tanks ok. Must

   be secured and does not move. No gas tank protectors.

9. Battery can be moved to passenger seat. Must be secured and covered. If left in stock

   location, you can use spray foam around battery.

10. Windshield can be removed. If removed must run 2 windshield bars. One in front of driver

    other in middle of cowl.

11. The following must be removed prior to entering fairgrounds. Windows, headlights, tail

    lights, all chrome and mirrors. Interior must be swept clean of debris and glass.

12. Stock springs and shocks. No solid suspensions. Spring risers ok, 2 per spring. Wire chains or any weld on rear end spring pockets. Cars must bounce and be stock. Bottom of bumper heights. Car must sit no higher 21” from ground to bottom of bumper. No lower than 16” from ground to bottom of bumper.

13. Bar behind seat is highly recommended. 4 point floating cage and rollover bar ok. Can not be welded to roof. Use gussets off back bar.

14. Car must look and be stock

15. Paint drivers door in orange or yellow.

16. Battery may be moved inside of car. 1 battery only. If moved it must be secured and covered.

    If left in stock you can spray foam around battery.

17. Bumpers can be welded on including bumper shocks. DEC type bumpers ok. NO POINTY

    BUMPERS. Homemade bumpers are allowed. Ends must be open.

18. Read rules carefully and follow them! This is a cheap and easy build. Any questions call!

    There will no starching or bending of rules. NO REFUNDS!!!!!

19. Once cars are inspected, they will be put in an impound area. No one is allowed to touch car

    in impound area.

20. All car numbers must be legible.

21. 4 each fix plates. 4”x4”x1/4”. Must be 1” in between welds